Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Fireplace Repair Across Midwood
If your fireplace is smoking, your damper won’t close, or your gas logs won’t stay lit, you’re in the right place. We handle fireplace repair across Midwood, and we know the older brick semis and small apartment buildings on these blocks well. That matters here, because a Midwood chimney often isn’t a simple one-house fireplace setup. If you’re dealing with a problem right now, call (866) 937-7157. We answer 24/7, and we book every job around a written estimate you approve first. Nothing gets recommended until you’ve seen the camera footage for yourself.
Why Midwood Homeowners Call Chimney Sweep Flatbush for Fireplace Repair
Most of the fireplace and chimney work we get called for in Midwood comes from one honest truth: these houses were built before anyone thought much about how a chimney interacts with a modern gas appliance. We bring a straightforward approach to that – we inspect before we recommend, and we don’t quote a reline or a rebuild until a camera has been down the flue and you’ve watched what it found.
That gets us repeat calls from owners and property managers on the Ocean Parkway service roads and the side blocks around them. Homeowners here tend to be skeptical of anyone waving a clipboard and a big number before lunch, and we’re fine with that. We’d rather show you the evidence and let you decide, even when that answer is “this can wait until spring.”
We also know how these stacks are built, which saves a lot of guesswork. On a shared party-wall stack in a Midwood semi, the flue that serves your fireplace might not be the one you think it is, and finding that out early is half the repair. Our technicians have up to 9 years of experience with exactly this kind of system.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Fireplace Repair Services in Midwood
We cover the fireplace and the flue that serves it as one system. In Midwood’s older housing stock, that means we look at the firebox, the damper, the smoke chamber and the clay tile together before we put a number on anything.
Damper Repair
A damper that won’t open, won’t close, or won’t seal is one of the most common calls we get from Midwood homes. When the chimney crown above has cracked and let water into the smoke chamber, the damper is often the first thing to seize or warp. We repair or replace the damper after we’ve traced why it failed, so you’re not fixing the same part again next winter.
Firebox Repair
Mortar crumbs on the firebox floor are a warning sign here. In a 1930s brick semi, water tracking down a cracked crown can work into the firebox joints and the smoke shelf over decades of freeze-thaw. We rebuild and repoint firebox panels where the damage is surface-level. If the brick behind is sound, a targeted firebox repair can spare you from a rebuild you don’t need.
Gas Fireplace Repair
Plenty of Midwood fireplaces now vent a gas boiler or water heater through the same stack the old fireplace used. We repair gas fireplace and insert issues – a pilot that keeps going out, weak flame, sooting – and we check how the appliance vents through a flue that might have been originally sized for coal. That sizing mismatch is often the real cause of a problem that looks like a repair.
Wood Burning Fireplace Repair
Some Midwood homeowners still burn wood, and we support them where the flue can safely handle it. A wood-burning fireplace in an older house needs a sound flue, a damper that seals, and a smoke chamber that isn’t full of crumbling mortar. We inspect each of those before recommending anything, because a wood fire venting into a degraded clay tile is a genuine fire risk.
Trusted Brands We Service in Midwood
When a repair calls for a part or a material, we work with professional-grade chimney industry brands, not hardware-store substitutes. We fit DuraFlex flexible liner systems for retrofits in older or non-standard chimneys where a rigid liner won’t go. We use Olympia Chimney components in repair and relining work, and Copperfield specialty tools and materials in our sweep and inspection work. We don’t claim to stock parts or keep a warehouse of inventory, and we won’t tell you we have a specific component on a shelf before we’ve checked the job. What we can promise is that the materials we install are the same grade commercial contractors use, and that the written estimate names what’s going in.
Common Fireplace Repair Problems We See in Midwood Homes
- Water in the smoke chamber from a cracked crown. Freeze-thaw cycles through the winter stress the mortar on exterior brick crowns, and a hairline crack lets rain into the flue. A nor’easter or a heavy summer downpour can turn that into a leak you notice on the firebox floor or the ceiling below.
- A flue originally sized for coal, now venting gas. Many Midwood chimneys were built for coal then converted for gas boilers and water heaters. The clay tile may be too large for the appliance, and decades of exhaust have degraded it in ways you can’t see without a camera.
- A rusty or sticking damper. When water reaches the smoke chamber, the damper is usually the first moving part to fail. A damper that doesn’t seal lets heat and smoke back into the room and pushes your heating cost up.
- Cross-address leakage on a shared stack. On a party-wall chimney serving two attached houses, water or creosote can track through shared mortar joints into the neighbor’s flue. The leak you see in your unit may not have started on your side.
The Party-Wall Chimney Problem Specific to Midwood Semis
Here’s the one thing that makes fireplace work in Midwood different from most of the region. On block after block of 1920s-1930s brick semis and detached houses, the chimney isn’t a single-house affair. It’s a shared party-wall mass that serves two addresses. One flue may feed your fireplace while the one beside it vents next door, or the same tile may serve appliances on both sides through shared mortar joints.
That changes how a repair has to start. We map which flue serves which address before we touch anything – and that means a camera run down each flue and a note of which tile goes where. On a shared stack, fixing a flue tile or damper for one house can change the neighbor’s draft or leak path, so we knock next door and coordinate access and liability across the property line before any work begins. This is also where the worst upselling in the trade happens, and where a homeowner has no way to verify a big repair number. We don’t recommend a repair without camera evidence you can watch.
In a typical Midwood semi, the boiler flue and a former wood fireplace share one exterior brick stack with clay tiles. Decades of freeze-thaw crack the crown, water reaches the smoke chamber, and you find mortar crumbs on the firebox floor and a damper that sticks. The repair usually means rebuilding the crown, sealing or replacing the damper, and relining only the flue with visible evidence of spalling or gaps – never a blanket recommendation across the whole stack.
See the difference
Before
After
Before
After
Before
AfterPricing for Fireplace Repair in Midwood, NY
We work from a written estimate, so you approve the price before we start. Typical ranges for common fireplace repairs in Midwood:
- Damper repair or replacement: $180-$450
- Firebox repointing or panel repair: $350-$800
- Gas fireplace or pilot light repair: $150-$400
- Chimney crown rebuild: $400-$900
- Camera inspection with a photo report: $150-$300
- Spot relining where evidence supports it: $900-$2,500
The final price depends on the flue geometry, how much of a shared stack is involved, and whether the work needs to coordinate with a neighbor. A standalone inspection is available on its own, so you can get a documented, honest assessment before committing to any repair. Estimates are free, and we’ll tell you plainly when work can safely wait.
We Also Serve Cities Near Midwood
We take fireplace and chimney work across the neighborhoods around Midwood, including Flatlands, Kensington, Flatbush, and Borough Park. The brick housing stock and the older chimneys are much the same from one to the next, so the approach carries over. If you’re right here in Midwood, that’s our home ground for this kind of repair, and we’d be glad to look at fireplace issues in the surrounding towns too. Wherever you are, a call starts with a free estimate.
Serving Midwood, NY – Our Local Coverage Area
We serve Midwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Fireplace Repair in Midwood
There’s no one right answer because it depends on which flue serves which address, and the documentation is what settles it. That’s why we map the flues to each address with a camera before any work. If the damage turns out to be on a shared stack, we coordinate access and liability across the property line with your neighbor rather than assigning blame. Call (866) 937-7157 to set up an inspection that documents the mapping – estimates are free.
Yes, in most 1930s Midwood houses a camera-based inspection is the right first step before a damper repair. A stuck or warped damper is usually a symptom, often of water getting in through a cracked crown, and a repair without finding the water source means you’re fixing the part twice. A Level 2 inspection lets us see the flue condition and the smoke chamber. Call (866) 937-7157 to book one – estimates are free.
The pilot on a gas fireplace going out after a nor’easter usually points to draft problems or water getting into the flue or vent termination. A strong wind can create downdraft, and a cracked crown or uncapped flue lets rain reach the appliance area. We inspect the flue and the appliance venting as one system before quoting a repair. Call (866) 937-7157 for an exact quote – estimates are free.
Often yes, if the camera shows the flue itself is sound. A firebox floor repair is a separate job from relining, and we don’t bundle them unless the evidence supports both. We look at the flue first because a wood fire venting into a degraded clay tile is a fire risk, then tell you what’s safe to repair on its own. Call (866) 937-7157 and we’ll walk you through what the inspection would cover – estimates are free.
An unlined clay-tile flue often needs either a stainless liner or resurfacing, but the right path depends on the tile’s condition and size. We use DuraFlex flexible liner systems for retrofits where a rigid liner won’t fit older geometry, and HeatShield resurfacing as a structurally sound, cost-effective alternative to a full liner replacement when the tiles are intact enough to support it. Nothing gets recommended until the camera shows which case you’re in. Call (866) 937-7157 for an exact quote – estimates are free.
What Happens When You Call
You call, you tell us what the fireplace is doing, and we set up an inspection and free estimate. We run a camera down each flue, document which tile serves which appliance, and knock next door if you’re on a shared party-wall stack. Then we show you the footage and give you a written estimate with the final price on it – after that, you approve and we book the work. If it turns out the fireplace can safely wait, we say so. Call (866) 937-7157. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Flatbush.