Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Flatbush
Most chimney cap and crown work in Flatbush isn’t about a wood fire at all. It’s about keeping rain out of century-old brick stacks that vent basement boilers and gas water heaters. We know these roofs, we know these flues, and we can usually tell you what’s wrong from the camera before anyone climbs up to sell you something. Our technicians have up to 9 years of experience on exactly this kind of housing. Call (866) 937-7157 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Flatbush Homeowners Call Chimney Sweep Flatbush for Chimney Cap & Crown
We work Flatbush chimneys week in and week out, and the homes here have a specific set of problems. The two- and three-story brick rowhouses and Victorian-era houses built between 1890 and 1930 almost all still carry original clay tile flues, and a lot of them were never lined at all. Those flues were run to serve oil-fired boilers and gas water heaters, and they’re venting combustion gases every winter whether the fireplace ever gets lit or not.
That changes how we approach cap and crown work. It’s venting safety for heating appliances inside aging masonry, not just a sweep-and-go job. We inspect before we recommend, every time. When we tell you a crown is failing or a flue needs attention, you get camera photos of the crown, the flashing and the inside of the flue so you can see what we see. No upsell on a roof glance.
Flatbush customers tell us the same thing after we leave: they finally understood what was going on up there. Our technicians have up to 9 years of experience, and we use professional-grade brands like Famco and Olympia Chimney for caps, plus HeatShield for crown and flue work where it fits. That matters in a market where a lot of caps get quoted before anyone confirms the flue condition underneath.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Flatbush
We cover the full crown and cap side of the chimney system, and we do it on the same brick stacks that have been on these blocks for well over a century. A typical Flatbush call starts with a boiler or gas water heater vented into an original clay-tile or unlined flue inside a 1900s brick stack, where the mortar crown has cracked and freeze-thaw has driven water into the brick above the roofline. A qualified technician runs a Level 2 inspection with a camera, photographs the spalling crown, flashing and flue interior, and usually proposes a cast crown repair or crown coating plus a correctly sized multi-flue cap rather than a rebuild. The same visit often turns up first-degree creosote or debris blocking draft, which is swept before any cap is set. That’s the order that keeps you from paying for a cap over a flue that’s still failing.
Cap Installation
A correctly sized cap is the simplest thing you can do to keep rain and nesting birds out of a Flatbush clay tile. We match the cap to the flue opening so it actually covers the tile without choking the draft your boiler needs. On these rowhouses that fit matters more than the model name on the box.

Cap Replacement
Single-flue and undersized caps get pulled loose or crushed by weather and animals, and once that happens the tile is open to rain and debris. Replacing a failed cap is usually a short job, and it’s one we size properly the second time. We check the flue condition before we set anything new on top.

Crown Repair
Original mortar crowns on 1890s – 1920s stacks crack through freeze-thaw and nor’easter rain, and water then runs down the flue and spalls the brick above the roofline. Crown repair rebuilds the slope and the overhang so water sheds off the stack instead of into it. We photograph the failed crown first so you can see exactly where it’s letting water in.

Crown Coating
When a Flatbush crown has hairline cracks but is still structurally sound, a coating can seal it without a full tear-out. It’s the less expensive path, and it’s the one to consider when the camera shows the crown body is intact. We’ll tell you plainly when coating will hold and when it won’t.
For the full scope of this work, see our chimney cap & crown page.
Trusted Brands We Service in Flatbush
We source and install caps and crown materials from established chimney industry brands, and we name them because materials matter. Famco and Olympia Chimney caps are what we commonly fit on Flatbush roofs, and HeatShield resurfacing handles the crown and flue work where the flue is sound but worn. DuraFlex flexible systems come in for retrofits on older or non-standard stacks where a rigid liner physically won’t fit. We don’t warehouse parts and we don’t claim to. We order what a specific job needs and book the work around it, which keeps the turnaround tight.
Common Chimney Cap & Crown Problems We See in Flatbush Homes
The failure patterns here are consistent across blocks, because the housing was mostly built in the same thirty-year window.
- Cracked mortar crowns on 1890s – 1920s stacks. Flatbush’s cold, damp winters run the heating hard from November through March, and freeze-thaw plus nor’easter rain work those cracks wider each year. Once water gets in, it spalls the exterior brick above the roofline.
- Loose or crushed single-flue caps. Undersized caps lifted by wind or packed with nesting debris leave the clay tile open to rain. That worsens draft for basement boilers and gas water heaters that vent through the same stack.
- Shared party-wall stack problems. On many Victorian Flatbush blocks the chimney stack is shared between adjacent rowhouses, so a flue issue in one house can quietly affect the neighbor’s venting. Capping or re-crowning one side without assessing the adjoining flue can trap moisture or change draft on the neighbor’s boiler and water heater.
- Caps and crowns quoted off a roof glance. This is where the worst upselling happens. Unlined or clay-tile flues get pushed toward relining before any Level 2 inspection shows the actual condition. The camera report is what should drive the decision, not the view from the ladder.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Flatbush, NY
A typical chimney cap in Flatbush runs $185 – $450, and a crown repair runs $400 – $1,100 depending on how much of the crown has to be rebuilt. Crown coating on a sound crown with hairline cracks runs $350 – $750. A multi-flue cap on a shared or multi-appliance stack runs $400 – $850, and a custom-fit cap runs $550 – $1,200. What moves the price is the number of flues, the condition of the crown body, how much spalled brick has to be addressed first, and whether the stack is a party-wall structure that needs both sides looked at. Every price is an estimate, and the written estimate sets the final price. The estimate itself is free, and you’ll have the camera report in hand before you decide anything.
We Also Serve Cities Near Flatbush
We handle cap and crown work in the neighborhoods around Flatbush too: Kensington, East Flatbush, Flatlands and Crown Heights. The housing stock and the party-wall chimney layouts don’t change much across those lines, so the inspection approach carries over directly. If you’re just outside Flatbush, call and we’ll confirm coverage and booking for your address.
Serving Flatbush, NY – Our Local Coverage Area
We serve Flatbush and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Flatbush
Because a Flatbush stack usually serves more than one appliance, and a multi-flue cap covers all of them under one properly sized top. In most of these rowhouses the boiler and the gas water heater vent into separate flues inside the same brick stack, so a single cap leaves the other tile open. A multi-flue cap keeps rain and nesting debris out of every flue at once and maintains the draft the heating appliances need. Call (866) 937-7157 for an exact quote. Estimates are free.
It can, which is why we check both sides of a party-wall stack before recommending anything. On many Victorian Flatbush blocks the chimney is a shared structure, and capping or re-crowning one side without assessing the adjoining flue can trap moisture or alter draft on the neighbor’s boiler and water heater venting. We photograph both sides and tell you what the shared stack needs. Call (866) 937-7157 for an exact quote. Estimates are free.
You know from a Level 2 camera inspection, not from a glance off the roof. If the flue interior is intact clay tile with no cracking or spalling, a correctly sized cap is what’s missing. If the camera shows the tile has failed or the flue is unlined and venting a boiler, then relining is the conversation. Nothing gets recommended without camera evidence you can see for yourself, and we’ll say plainly when work can safely wait. Call (866) 937-7157 for an exact quote. Estimates are free.
Water getting into the brick above the roofline, usually through cracks in an original mortar crown. Flatbush’s freeze-thaw cycles and nor’easter rain drive moisture in, and when it freezes it pushes the face of the brick off, which is the crusty flaking you’re seeing. Crown repair or coating plus a proper cap stops the cycle. Without it, the spalling keeps working deeper into the stack. Call (866) 937-7157 for an exact quote. Estimates are free.
Yes. NFPA 211, the national chimney standard, applies to any vented appliance, so a boiler and a gas water heater vented into a masonry flue are held to the same inspection requirement as a fireplace. A lot of Flatbush homes here have never had a formal inspection because there’s never been a wood fire in the firebox. That leaves an unlined or clay-tile flue venting combustion gases with no documented condition on record. Call (866) 937-7157 for an exact quote. Estimates are free.
Book Your Flatbush Cap and Crown Service
If your crown is cracked, your cap is loose or missing, or you simply want the condition of an old Flatbush stack documented before winter, call us. We inspect first, photograph what we find, and put the price in writing before any work is booked. The estimate is free. Call (866) 937-7157. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Flatbush.