Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Prospect Heights
If you own a brownstone or rowhouse in Prospect Heights, your chimney is probably older than the building’s plumbing and shares a stack with the house next door. Caps and crowns here aren’t a cosmetic upgrade. They’re the first line of defense against water tracking down a narrow 19th-century flue and into your firebox. We know how these shared stacks are put together, we know the rear-bulkhead roof access that comes with this housing, and we know what freeze-thaw does to a mortar crown through a Brooklyn winter. Call (866) 937-7157 and we’ll talk through what you’re seeing. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Prospect Heights Homeowners Call Chimney Sweep Flatbush for Chimney Cap & Crown
Prospect Heights is dense, low-rise, and almost entirely attached housing, and that shapes every job. A cap that seals one flue on a shared stack can leave the neighbor’s flue pulling cross-drafts if it isn’t sized and fitted for the whole chimney top. We inspect before we recommend, which matters more here than almost anywhere else in Brooklyn. Our technicians have up to 9 years of experience, and they’ve spent a lot of that time on pre-war masonry chimneys in buildings like the ones lining the blocks near Grand Army Plaza and along Vanderbilt Avenue.
We handle the full chimney system – liner, cap, crown, firebox, and flue – under one provider, so nobody has to hand you off between trades when a party-wall stack needs coordinated work. Our local reputation in Prospect Heights rests on that scope and on being straight with homeowners about what can wait. If a crown only needs coating, we’ll say so. If a neighbor needs to be brought in before a multi-flue cap makes sense, we’ll say that too. We serve Prospect Heights along with the surrounding blocks, and we can work with your insurer when storm or water damage is part of the picture.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Prospect Heights
Cap Installation
A properly sized cap keeps rain, squirrels, and birds out of a flue that was never built with a modern rain guard. On Prospect Heights rowhouses, the cap has to fit a narrow flue opening inside an old brick crown, and it has to sit high enough not to trap moisture against the masonry. We fit Gelco and Olympia Chimney caps to manufacturer spec so the seal holds through a Northeast winter.

Cap Replacement
Missing, rusted, or undersized caps are one of the most common things we find on Prospect Heights chimneys. A cap that’s too small funnels water straight into the flue instead of shedding it off the crown. When we replace a cap here, we check the flashing and the crown at the same time – a new cap on a cracked crown just moves the leak a few inches down.

Crown Repair
The crown is the mortar cap at the top of the chimney, and it’s the piece that takes the most abuse from freeze-thaw cycling in this climate. On a shared stack, a cracked crown lets water into both units’ flues, which is why crown repair in Prospect Heights often means looking at the whole chimney top rather than one side of it. We repair spalled and cracked crowns and rebuild the slope so water runs off instead of pooling.

Crown Coating
Not every crown needs to be torn out and rebuilt. When the mortar is sound but the surface is cracking, we apply HeatShield resurfacing as a flexible, structurally sound coating that moves with the masonry instead of splitting away from it. It’s a cost-effective path that avoids a full rebuild, and on a Prospect Heights rowhouse it’s often the right call for a crown that’s aging but not failing.
Trusted Brands We Service in Prospect Heights
We source and install from professional chimney supply brands – DuraFlex for flexible liner systems where a rigid liner won’t fit an old flue, HeatShield for crown and liner resurfacing, and Gelco, Olympia Chimney, Famco, and Copperfield for caps, tools, and materials. These are the same materials commercial contractors use, not hardware-store substitutes. We don’t stock parts or run a warehouse; we specify the right component for your chimney and fit it to manufacturer spec. That keeps turnaround tight and means the cap or crown you get is the one the job actually called for.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in Prospect Heights Homes
- Cracked mortar crowns on shared stacks. Decades of freeze-thaw cycling split the crown and let water into both units’ flues, which shows up as spalling brick and rusted dampers below. On a party-wall chimney, one cracked crown is a two-household problem.
- Missing or undersized caps. Narrow original flues on these rowhouses clog fast when rain and animals get in, and a cap that’s too small for the opening doesn’t keep them out. Poor draft and blockages usually trace back to this.
- Adjacent flues venting into the same stack. When the neighbor’s appliance shares your stack, cross-contamination becomes real – a cap sized for one flue may not seal the shared chimney top effectively. This is why multi-flue and custom caps matter here.
- Sealed fireplaces left uninspected. Many Prospect Heights fireplaces have been capped and sealed over the years, but the chimney above them still takes on water. A capped flue with a failing crown is a slow leak nobody notices until the plaster stains.
Pricing for Chimney Cap & Crown in Prospect Heights, NY
Here’s what cap and crown work typically runs in this market. A standard single-flue cap installation in Prospect Heights usually runs $250 to $550, and cap replacement in the same range. Crown repair on a masonry chimney typically runs $400 to $900 depending on the size of the crown and how much rebuilding is needed. Crown coating with HeatShield resurfacing usually runs $350 to $700. A multi-flue or custom cap for a shared party-wall stack typically runs $600 to $1,200, since it has to be fitted to more than one flue opening. These are estimates – the written estimate sets the final price, and we give you one before any work is booked. The estimate is free. Call (866) 937-7157 for an exact quote.
We Also Serve Cities Near Prospect Heights
The same party-wall chimney work comes up across the surrounding neighborhoods, and we serve them the same way we serve Prospect Heights. If you’re in Clinton Hill, Park Slope, Williamsburg, or Crown Heights and your chimney shares a stack with a neighbor, the conversation is the same. Our chimney cap & crown team can take a look and tell you what’s actually going on up top.
Serving Prospect Heights, NY – Our Local Coverage Area
We serve Prospect Heights and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Prospect Heights
No – capping one flue on a shared stack without accounting for the neighbor’s flue can create cross-drafting and shared moisture problems. On a party-wall chimney, each flue needs its own properly sealed cap, which usually means a multi-flue or custom cap fitted to the whole chimney top. We inspect the shared stack first and explain what the neighbor’s side needs before anything is installed. Call (866) 937-7157 for a free estimate.
If the mortar is sound and the damage is surface cracking, a HeatShield coating is usually enough; if the crown has spalled through or lost its slope, it needs repair or a rebuild. We inspect before we recommend, so the decision is based on what’s actually there, not a guess. Call (866) 937-7157 and we’ll take a look.
Water getting past a cap usually means the crown or flashing is failing, or the cap is undersized for the flue opening. In a typical Prospect Heights rowhouse, a homeowner notices a musty smell or a water stain near the firebox after heavy rain, and an inspection finds the original crown has cracked from decades of freeze-thaw cycling. Because the chimney sits in the party wall, the adjoining unit’s flue often vents into the same stack, so the fix involves repairing the crown and making sure each flue has its own sealed cap. Call (866) 937-7157 for a free estimate.
Yes – a sealed fireplace still has a chimney above it taking on water, and capped unused flues are the norm in Prospect Heights. The real question is whether that chimney is safe to leave sealed, and you can’t answer it without looking at the crown and cap. Call (866) 937-7157 to book an inspection.
A multi-flue cap covers several flue openings on one chimney with a single unit, while a custom cap is built to the exact dimensions of a non-standard or shared stack. On Prospect Heights party-wall chimneys, the flue openings and crown size often don’t match off-the-shelf dimensions, so a custom fit is frequently the right answer. Call (866) 937-7157 and we’ll tell you which one your chimney needs.
If your crown is cracked or your cap is missing, don’t wait for the next freeze-thaw cycle to make it worse. Call (866) 937-7157 for a free estimate on chimney cap and crown work in Prospect Heights. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. We inspect before we recommend, and the written estimate sets the price before anything is booked.
Written by the team at Chimney Sweep Flatbush.