Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Clinton Hill
If you own a brownstone or rowhouse in Clinton Hill, the cap and crown on top of your chimney are quietly taking the worst of what this neighborhood throws at them: wet winters, freeze-thaw cycles, and a century of soot. We work on chimneys across Clinton Hill, from the landmark blocks near the Pratt campus to the converted carriage houses off Fulton and the brick rows toward Myrtle. Cap and crown problems are usually small, fixable, and best caught before water gets inside. Call (866) 937-7157 and we’ll book a visit, walk the stack with a camera, and tell you what we see.
Why Clinton Hill Homeowners Call Chimney Sweep Flatbush for Chimney Cap & Crown
Most of the work we do in Clinton Hill starts with the same sentence: “I don’t know if I actually need this.” That’s fair. Older chimneys here hide their problems behind ornate parlor mantels, and plenty of contractors are happy to sell a rebuild before anyone has looked up the flue. Our approach is inspection first. We run a camera, show you the footage, and explain what needs attention now versus what can wait. No recommendation goes on paper without evidence you can see for yourself.
We serve Clinton Hill alongside our home base in Flatbush, and we know how these houses age. The 1860s-to-1900s rowhouses and brownstones here share party-wall stacks with original clay tile liners, and those liners crack and spall after a hundred-plus years of freeze-thaw and old coal soot. That history shapes every estimate we write. Our technicians have up to 9 years of experience, and one company handles the full system: liner, cap, crown, firebox, and flue. You call one number and stay with one company from the first look to the final fit.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Clinton Hill
Cap and crown work is one category of our Chimney Cap & Crown service, and in Clinton Hill the priorities tend to run toward crown repair, multi-flue caps, and careful cap installation that fits the flue size. Here’s how each one plays out on local homes.
Cap Installation
A properly sized cap keeps rain, birds, and debris out of the flue and lets smoke escape. On Clinton Hill’s older shared stacks, flue sizes rarely match, so a generic hardware-store cap often seals poorly and worsens draft. We fit caps from established suppliers like Famco and Olympia Chimney, measured to the actual clay tile opening, with low-profile styles that suit landmark-district rooflines.

Cap Replacement
Rusted, loose, or undersized caps are common on Clinton Hill rowhouses, especially where an old damper or stovepipe connector has been corroding through humid summers. We remove the failing cap, check the flue opening and crown while we’re up there, and set a correctly sized replacement. If the crown needs work too, we fold it into one visit rather than making two trips.

Crown Repair
The crown is the mortar cap that sheds water away from the brick and flue. On Clinton Hill brownstones, soft brick crowns spall after repeated freeze-thaw cycles, opening cracks that channel water straight into the flue. Repair means rebuilding the damaged section to the right slope and material so water moves off the stack, not into it. This is the single most common fix we make on local party-wall chimneys.

Crown Coating
Where the crown is sound but showing hairline cracks, a flexible coating can seal it without a full rebuild. That matters in Clinton Hill, where landmark rules push many owners toward repairs that avoid visible exterior masonry changes. Coating is the lower-cost path when the mortar is still holding. We only recommend it after the camera shows the damage is surface-level, because a coating over a failing crown just hides the problem for a season.
Trusted Brands We Service in Clinton Hill
We source and install from professional-grade chimney suppliers: DuraFlex flexible liner systems, Olympia Chimney and Famco caps, and Copperfield tools and materials in our sweep and inspection work. That means parts sized and specified for real flues, not generic substitutes. We don’t claim to keep these in stock in Clinton Hill. We order what the job needs and fit it to the measured flue. When a retrofit calls for a flexible system because a rigid liner simply won’t fit an old stack, DuraFlex handles the tighter bends that Clinton Hill’s non-standard configurations often require. The spec comes from what the camera shows, not from what’s on a truck.
Common Chimney Cap & Crown Problems We See in Clinton Hill Homes
- Spalling brownstone crowns. Soft brick crowns on Clinton Hill’s 19th-century chimneys crack and flake after repeated freeze-thaw cycles. Each small crack channels water into an unlined or clay-tile flue, and the damage compounds winter after winter.
- Patched crowns that keep leaking. On landmark-district blocks, exterior masonry changes often need Landmarks Preservation Commission approval, so failed crowns sometimes get patched instead of replaced. A patch over a hidden crack still leaks, and the water finds the flue anyway.
- Mismatched caps on shared stacks. Clinton Hill’s party-wall stacks carry different flue sizes, so one cap rarely fits all openings. A generic cap installed without camera verification often seals wrong and pulls smoke back down the flue.
- Corroded dampers and connectors on idle chimneys. Many brownstone fireplaces were retrofitted for gas or left unused for decades. Humid summers rust out the old damper and stovepipe connector even when the hearth never gets lit, so the cap and crown need a look regardless.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Clinton Hill, NY
Here’s what cap and crown work typically runs in Clinton Hill. A standard cap installation runs $250 – $550 depending on flue size and cap type. A multi-flue cap for a shared stack runs $425 – $850. Crown coating runs $200 – $450, and a crown repair or rebuild runs $450 – $1,200 depending on how much masonry has failed and whether it’s reachable from the roofline. Budget another $150 – $400 for the camera inspection that confirms what’s actually needed. Landmark-district jobs can add cost if approval and low-profile specifications are involved. Every price here is an estimate, and the written estimate sets the final price. Estimates are free.
We Also Serve Cities Near Clinton Hill
Chimney Sweep Flatbush handles cap and crown work throughout Clinton Hill and the neighborhoods around it, including Prospect Heights, Williamsburg, Park Slope, and Crown Heights. If you’re just over the line from Clinton Hill, the same camera-first approach applies. Call (866) 937-7157 and we’ll book a visit to your block.
Serving Clinton Hill, NY – Our Local Coverage Area
We serve Clinton Hill and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Clinton Hill
Possibly, depending on whether the crown is visible from the street. On landmark-district blocks in Clinton Hill, visible exterior masonry changes often need Landmarks Preservation Commission approval, which is why many crown jobs here lean toward interior relining and repairs that stay out of public view. We’ll tell you what we see on the camera and flag where approval may be needed before any work is booked. Call (866) 937-7157 for an exact quote – estimates are free.
You usually can’t tell from the ground, which is why we measure the flue opening directly. A correctly sized cap covers the full tile opening with proper clearance for draft, and on Clinton Hill’s shared stacks that often means a custom or multi-flue fit rather than a standard size. The camera inspection settles it. Call (866) 937-7157 for an exact quote – estimates are free.
Because the original mortar wasn’t made for the freeze-thaw cycles Clinton Hill sees now, and a patch that doesn’t restore the correct slope or material will crack again. Coastal New York winters open the same seam each season. A proper rebuild with the right mortar and slope holds far better than repeat patching. Call (866) 937-7157 for an exact quote – estimates are free.
Crown repair rebuilds failed masonry; crown coating seals a sound crown with hairline cracks. Repair is the fix when the mortar has failed or the slope is gone. Coating is the lower-cost option when the crown is structurally intact. We only recommend one or the other after the camera shows the actual condition. Call (866) 937-7157 for an exact quote – estimates are free.
Yes. An unused chimney still lets water in through a cracked crown or missing cap, and that water rusts the damper and damages the flue from the inside, even on a fireplace nobody lights. Clinton Hill has plenty of dec
ades-idle brownstone chimneys in exactly this condition. A camera inspection tells you whether it’s holding. Call (866) 937-7157 for an exact quote – estimates are free.
Book a Cap & Crown Visit in Clinton Hill
If your Clinton Hill chimney is showing a cracked crown, a loose cap, or rust streaks near the damper, a camera inspection is the honest place to start, and you’re under no obligation to book repair work from it. We inspect before we recommend, and the footage is yours to see. Call (866) 937-7157 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Flatbush.